Quickstart

This is a Motor Control Class C for XXXQFrequencyName. To run this device please connect it to your mains power supply.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

Tubular motor mob.iq EZRS M35 10/14 by Mobilus Motor Company is a modern radio controllable drive, designed to drive rolling shields. This device has a number of innovative solutions, including:SENSO technology:- programming of endpoints automatically or using the remote control,- operation regardless of the used hangers type,- bidirectional obstacles detection which eliminates failures due to obstacles (each failure will be reported to controller as an alarm)- saving your time due to lack of supervision of your shutters - obstacle detection system, insensitive to minor disruption during work.But the most important feature of our motor is the usage of Z-Wave technology as the communication standard. It provides inter alia:- easy procedure of connection the device to the network,- bidirectional communication between the motor operator and control device - therefore the user has the opportunity to receive a variety of information about the motor operator (location, work errors, obstacles encountered in the blinds way of work),- automatic creation of network of devices, so there is no need for additional radio signal repeaters,- compatibility with third party control devices - Z-Wave is a mature standard for radio communication, chosen by over two hundred manufacturers of devices intended to create anintelligent home control systems.Technical parameters:- fi roller tube diameter of 35 mm,- torque: 10 Nm,- revolutions per minute: 14 rpm,- supply voltage 230 V.

Reset to factory default XXXResetDescription
Inclusion XXXInclusionDescription
Exclusion XXXExclusionDescription
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Hardware Platform ZM3102
Device Type Not Z-Wave Plus
Generic Device Class Switch Multilevel
Specific Device Class Motor Control Class C
Network Operation Not Z-Wave Plus
Firmware Version v.1
Z-Wave Version 4.54
Certification ID ZC08-16110002
Z-Wave Product Id 0x019D.0x0002.0x0001
Frequency XXfrequency
Maximum transmission power XXantenna
CEPT (Europe)Not Z-Wave Plus