This is a
You can add the device by either hardware button.-hardware button : Press the Add/Remove button.(1Second)1. Click an [Add] icon in Z-Wave PC Controller Program2. Press the hardware button in a Kumho light lamp for 1 second3. The device will be added to the Z-Wave network
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
Use eco-friendly LED lighting that can replace conventional lighting for energy Saving.After install household lighting in a room. you can control of turn on/off LED lighting from inside and outside, also control brightness and color temperature of lamp for variety of moods.Use extra Gateway for control operation the above function.
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is inoperable.
"Use this procedure only when the network primary controller is missing or otherwise inoperable."1. Press the hardware button in a Kumho light lamp for 10 seconds2. Device Reset Locally notification will be sent
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Here are a few hints for network installation if things dont work as expected.
Z-Wave devices control other Z-Wave devices. The relationship between one device controlling another device is called association. In order to control a different device, the controlling device needs to maintain a list of devices that will receive controlling commands. These lists are called association groups and they are always related to certain events (e.g. button pressed, sensor triggers, ...). In case the event happens all devices stored in the respective association group will receive the same wireless command wireless command, typically a 'Basic Set' Command.
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Z-Wave Plus Lifeline |
Hardware Platform | WML-C85 |
Device Type | Light Dimmer Switch |
Network Operation | Always On Slave |
Firmware Version | FF |
Z-Wave Version | 6.51.06 |
Certification ID | ZC10-16010001 |
Z-Wave Product Id | 0x023A.0x0001.0x0001 |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |