This is a
Let your primary Controller/gateway into Inclusion mode, then press once the "Learn" Button in the app of Touch.
Oomi Touch is a smart mobility device based on the android OS. It is not only a touch device but also a Z-Wave touch sensor, it has built in a Z-Wave module, which let you can easily receive its sensor notifications form anywhere in the world.It is also a security Z-Wave device and supports the Over The Air (OTA) feature for the products firmware upgrade.
Reset to factory default | Press the "Reset" button in the app of Touch. This procedure only be used when the primary controller is missing or inoperable. |
Inclusion | Let your primary Controller/gateway into Inclusion mode, then press once the "Learn" Button in the app of Touch. |
Exclusion | Let your primary Controller/gateway into Exclusion mode, then press once the "Learn" Button in the app of Touch. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Z-Wave Plus Lifeline.The Notification Report CC or Hail CC can be sent in this association group. |
Reset your Touch. Size: 4 Byte, Default Value: 0
Setting | Description |
---|---|
0 | Reset the configuration parameters to default settings. |
1431655765 | Reset the Touch to factory default settings. |
To configure which command will be sent when the Sensor is triggered. Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 | Send Notification Report CC. |
1 | Send Hail CC. |
Hardware Platform | ZM5101 |
Device Type | Notification Sensor |
Network Operation | Listening Sleeping Slave |
Firmware Version | HW: 66 FW: 1.13 |
Z-Wave Version | 6.51.06 |
Certification ID | ZC10-16030007 |
Z-Wave Product Id | 0x016A.0x0102.0x0066 |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |