Enerwave Green Automation
In-wall Smart Meter Dimmer Switch
SKU: ZW500DM
Quickstart
This is a
When the primary controller is in the adding mode, flicks the paddle 3 times in the1.5 second. The primary controller will verify the adding, assign a node ID numberfor the module .
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The ZW500DM Dimmer Switch is a perfect wireless manual and remote on /off/dim brightness control replacement of regular switch, controlling incandescent,dimmable LED and CFL. This ZW500DM dimmer switch is fully compatible withother Z-Wave certified devices, provides programmable function creating a perfect ambiance such as scenes,association,schedule event,etc. Also it can be added to most Z-Wave compliant controllers. This ZW500DM dimmer works with ZW3K 3-Way Auxiliary Switch that reducing energy consumption, enhancing the value of technology of your home, condominiums and apartment. The ZW500DM Smart Meter Dimmer Switch enables you to measure the energy usage of your appliance. When added to a Z-Wave network, the ZW500DM reports real time data to your gateway or controller. It can also display actual consumption (in W) and the accumulated power used (in kWh) in the user interface of the gateway/remote. Please use the gateway installation manual for specific instructions on measuring the power.
| Reset to factory default | Flicks the program button 3 times in the 1.5 second then press once and hold for2 second.the device will send a device reset locally notification to controller. Thenclear all of information for the network, and restore factory defaults, and reset themodule. Use this procedure only in the event that the network primarycontroller is missing or otherwise inoperable. |
| Inclusion | When the primary controller is in the adding mode, flicks the paddle 3 times in the1.5 second. The primary controller will verify the adding, assign a node ID numberfor the module . |
| Exclusion | When the primary controller is in the removing mode, flicks the paddle 3 times inthe 1.5 second. The primary controller will verify the removing, remove the modulefrom the current Z-Wave network, and the LED will blink when the module is onpower |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 1 | Lifeline: Send device reset locally notification |
| 2 | 5 | StatusReport: Send basic report |
| 3 | 5 | PowerReport: Send meter power report |
Configuration Parameters
Parameter 1: LEDdirect
synchronization of loadpower and LED indicator Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Power on, LED off |
| 1 | Power on, LED on |
Technical Data
| Hardware Platform | ZM5202 |
| Device Type | Light Dimmer Switch |
| Network Operation | Always On Slave |
| Firmware Version | HW: 1 FW: 5.10 |
| Z-Wave Version | 6.51.07 |
| Certification ID | ZC10-16065122 |
| Z-Wave Product Id | 0x011A.0x0111.0x0201 |
| Switch Type | Decorator Paddle Push |
| Supported Meter Type | Electric Energy |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |