Quickstart
This is a
secure
Notification Sensor for XXXQFrequencyName.
To run this device please make sure the internal battery is fully charged.
To add this device to your network execute the following action:
Put the Z-Wave Interface Controller into inclusion mode, and following its instruction to add the ZS 5101-5 to your controller.To get in the inclusion mode, please press the program switch of ZS 5101-5 for 1 second at least to be included. The LED on the ZS 5101-5 should go off, if not, please try again.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
ZS5101US-5 detects vibrations made by an intruder attempting to break a window or door.It detects tamper situations and will send Z-Wave a signal when vibrations or tamper situations occur.When this device is securely included into the Z-Wave network, the above communications will be encrypted. * Non-Touch Vibration Design for Longer Lifetime* Adjustable Sensitivity* Tamper Switch* Battery Detection* LED Status Indicator* Battery Life: 2 Years
Reset to factory default |
*Push the Tamper switch then power on (put in the battery) & hold the Tamper switch for 5 seconds, ZD5101-5 will send the Device Reset Locally Notification command and reset to the factory default, LED will solid on, need to take off the battery and re-put in the battery to complete the function.*Please use this procedure only in the event that the network primary controller is missing or otherwise inoperable. |
Inclusion |
Put the Z-Wave Interface Controller into inclusion mode, and following its instruction to add the ZS 5101-5 to your controller.To get in the inclusion mode, please press the program switch of ZS 5101-5 for 1 second at least to be included. The LED on the ZS 5101-5 should go off, if not, please try again. |
Exclusion |
Put the Z-Wave Interface Controller into exclusion mode, and following its instruction to delete the ZS 5101-5 from your controller.Press the program switch of ZS 5101-5 for 1 second at least to be excluded. |
NIF |
XXXNIF |
Wakeup |
Use Wake Up command to set up the awaking time and send the wake up notification to controller.User can use command to change the auto wake up from 500 seconds to 1 week, Interval increment is 250 seconds. (Default: 6 hours)*Use Battery Get command to have the battery capacity back in % |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Z-Wave Plus Lifeline |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Notification Sensor |
Network Operation |
Reporting Sleeping Slave |
Firmware Version |
HW: 1 FW: 16.11 |
Z-Wave Version |
6.51.09 |
Certification ID |
ZC10-17015397 |
Z-Wave Product Id |
0x0109.0x2003.0x0308 |
Sensors |
Vibration/Shock (Binary) |
Color |
White |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |