Quickstart
This is a
Notification Sensor for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1) Set up the inclusion mode at the controller; 2) Briefly press the switch once and the controller will indicate the unit has been included in the network. Also, the LED will blink when the inclusion completes. Inclusion and exclusion are always done at normal transmit power mode. This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Connect your Basement Watchdog Battery Backup Sump Pump to your Z-Wave network and receive Sump Pump Alerts directly to your phone!From notifications when the backup system has turned on to problems with your pump motor or battery.You won't have to wonder any longer if your sump pump system is working properly.
| Reset to factory default |
The unit can be reset to factory default via 3 quick presses of the program switch. Please use this procedure only when the network primary controller is missing or otherwise inoperable. |
| Inclusion |
1) Set up the inclusion mode at the controller; 2) Briefly press the switch once and the controller will indicate the unit has been included in the network. Also, the LED will blink when the inclusion completes. Inclusion and exclusion are always done at normal transmit power mode. This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network. |
| Exclusion |
1) Set up the exclusion mode at the controller; 2) Briefly press the switch once and then release. The controller will indicates the unit has been removed from the network. The LED will blink when the exclusion completes. |
| NIF |
XXXNIF |
| Wakeup |
1 quick press of the program switch.The SPM will send the Z-Wave TM Node information frame when the switch is briefly pressed. This is primarily used for inclusion as described above. |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
5 |
Z-Wave Plus LifelineDevice Reset Locally (via 3 quick presses of the program switch)NotificationsoAC Mains DisconnectedoReplace Battery NowoSystem Hardware FailureSystem Hardware Failure with manufacturer-proprietary failure code (codes detailed below) |
| 2 |
5 |
NotificationsoAC Mains DisconnectedoReplace Battery NowoSystem Hardware FailureSystem Hardware Failure with manufacturer-proprietary failure code (codes detailed below) |
Technical Data
| Hardware Platform |
ZM5202 |
| Device Type |
Notification Sensor |
| Network Operation |
Always On Slave |
| Firmware Version |
HW: 3 FW: 1.20 |
| Z-Wave Version |
6.51.09 |
| Certification ID |
ZC10-17025429 |
| Z-Wave Product Id |
0x0084.0x0093.0x0114 |
| Firmware Updatable |
Updatable by Consumer by RF |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |
