Quickstart
This is a
secure
Notification Sensor for XXXQFrequencyName.
To run this device please make sure the internal battery is fully charged.
To add this device to your network execute the following action:
Pressing the button 'Inclusion Button' for one second will include the device. If the button is pressed for at least 2 seconds the inclusion will be done without the Security Command Class.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
This premium quality electrochemical Carbon Monoxide Alarm designed to North American standards with plug-in Z-Wave Communication Module provides a 10 year sensor life and is powered by two replaceable AAA batteries. The CO Sensor is monitored electronically and will report the following:1.Alarm on Sensing Carbon Monoxide2.Battery status reporting3.Sensor Fault4.Alarm removal from mounting plate5.Sensor End of LifeThe device is a secure Z-Wave Plus device and can be used in one wireless Z-Wave network with other Z-Wave certified devices.
| Reset to factory default |
To do a factory reset press the button on the bottom of the device for at least 10 seconds. This procedure should only be used when the primary controller is inoperable. |
| Inclusion |
Pressing the button 'Inclusion Button' for one second will include the device. If the button is pressed for at least 2 seconds the inclusion will be done without the Security Command Class. |
| Exclusion |
A single click on the button will exclude the device. |
| NIF |
XXXNIF |
| Wakeup |
A single click on the button will wakeup the device. |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
10 |
Z-Wave Plus Lifeline |
| 2 |
10 |
Alarm Reports |
| 3 |
10 |
Switching Command when Alarm |
Technical Data
| Hardware Platform |
ZM5202 |
| Device Type |
Notification Sensor |
| Network Operation |
Reporting Sleeping Slave |
| Firmware Version |
HW: 1 FW: 1.00 |
| Z-Wave Version |
6.51.06 |
| Certification ID |
ZC10-17035456 |
| Z-Wave Product Id |
0x026B.0x0004.0x0003 |
| Color |
White |
| Sensors |
Carbon Monoxide |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |
