This is a
Turn the primary controller of Z-Wave network into inclusion mode, press the Z-Wave Button on Range Extender 6.
Oomi Range Extender is a Z-Wave mesh network repeater which can extend the range of communication between Z-Wave products and assist other devices to reach each other in your Z-Wave network. The Range Extender can also communicate securely via AES 128 wireless Z-Wave commands and supports Over-The-Air (OTA) firmware upgrades.
Reset to factory default | Press and hold the Z-Wave Button for 20 seconds and then release it.Use this procedure only in the event that your primary network controller is missing or inoperable. |
Inclusion | Turn the primary controller of Z-Wave network into inclusion mode, press the Z-Wave Button on Range Extender 6. |
Exclusion | Turn the primary controller of Z-Wave network into exclusion mode, pressthe Z-Wave Button on Range Extender 6. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 1 | The association group 1 is the Z-Wave Lifeline group. The Device Reset Locally Notification CC can be sent to the associated node in association group 1. |
Enable/disable to lock Configuration parameters. Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 | Disable |
1 | Enable |
Set a device tag for your Range Extender. Size: 2 Byte, Default Value: 0
Setting | Description |
---|---|
1 - 32767 | The available value range is 1 to 32767. |
Reset the Bulb to factory default. Size: 4 Byte, Default Value: 0
Setting | Description |
---|---|
0 | Reset all configuration parameters to factory default settings |
1431655765 | Reset the bulb to factory default. |
Set the RGB value of the LED.Note: this parameter is only used to test the RGB LED, if you want to set its default RGB value, please use the Color Switch CC. Size: 4 Byte, Default Value: 0
Setting | Description |
---|---|
256 - 65535 | Green color value |
1 - 255 | Bule color value |
65536 - 16777215 | Red color value |
Set the default status ofthe LED when the Range Extender relays Z-Wave message Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 | The Green LED will remain ON for 2 seconds. |
1 | The LED remains OFF state. |
Hardware Platform | ZM5101 |
Device Type | Repeater |
Network Operation | Always On Slave |
Firmware Version | HW: 117 FW: 1.03 |
Z-Wave Version | 6.51.09 |
Certification ID | ZC10-17055582 |
Z-Wave Product Id | 0x016A.0x0104.0x0075 |
Firmware Updatable | Updatable by Consumer by RF |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |