Yale
Keyfree Connected
SKU: YKFCON
Quickstart
This is a
Put the Z-Wave controller into add modeEnter the Master code on the lock, followed by #Press the 4 button, followed by #Press the 1 button followed by #Refer to the operation manual of the Z-Wave controller to complete the add/inclusion processFor more information on this please visit:www.yale.co.uk/smart-living
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Keyfree Connected Ready smart lockFeaturesBattery operatedLow battery indicator with emergency battery connectionUser codes and settings remain if batteries are replaced3 minute lock out if code is entered incorrectly 5 timesTamper alarmFor use on UPVC & Composite Doors2 year guarantee
| Reset to factory default | Enter the Master code on the lock, followed by #Press the 4 button, followed by #Press the 0 button followed by #Please use this procedure only when the network controller is missing or inoperable |
| Inclusion | Put the Z-Wave controller into add modeEnter the Master code on the lock, followed by #Press the 4 button, followed by #Press the 1 button followed by #Refer to the operation manual of the Z-Wave controller to complete the add/inclusion processFor more information on this please visit:www.yale.co.uk/smart-living |
| Exclusion | Put the Z-Wave controller into remove modeEnter the Master code on the lock, followed by #Press the 4 button, followed by #Press the 2 button followed by #Refer to the operation manual of the Z-Wave controller to complete the remove/exclusion processFor more information on this please visit:www.yale.co.uk/smart-living |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | Z-Wave Plus Lifeline |
Configuration Parameters
Parameter 1: Volume
Volume of product during operation Size: 1 Byte, Default Value: 3
| Setting | Description |
|---|---|
| 1 | Silent |
| 2 | Low Volume |
| 3 | High Volume |
Parameter 2: Auto Relock
Auto relock On/Off Size: 1 Byte, Default Value: 255
| Setting | Description |
|---|---|
| 0 | Auto relock Off |
| 255 | Aut Relock On |
Parameter 3: Relock Time
Amount of time lock is opened before it relocks, after it has been unlocked by PIN code, key cards or key tags Size: 1 Byte, Default Value: 7
| Setting | Description |
|---|---|
| 7 - 60 | Amount of time (secs) |
Parameter 6: Remote Relock Time
Amount of time lock is opened before it relocks, after it has been unlocked by Z-Wave hub Size: 1 Byte, Default Value: 10
| Setting | Description |
|---|---|
| 10 - 90 | Amount of time (secs) |
Technical Data
| Hardware Platform | ZM5202 |
| Device Type | Door Lock - Keypad |
| Network Operation | Listening Sleeping Slave |
| Firmware Version | HW: 32 FW: 32.16:13.16 |
| Z-Wave Version | 6.71.01 |
| Certification ID | ZC10-18015918 |
| Z-Wave Product Id | 0x0129.0x0006.0x0001 |
| IP (Ingress Protection) Rated | ok |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |