Quickstart
This is a
secure
Notification Sensor for XXXQFrequencyName.
To run this device please make sure the internal battery is fully charged.
To add this device to your network execute the following action:
There is a button on PSM08.1. Have Z-WaveController entered inclusion mode.2. Pressing button once to enter the inclusion mode.3. After add successful, the device will wake to receive the setting command from Z-Wave Controller about 20 seconds.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
The door/window sensor PSM08 has door/window sensor function,based on Z-Wave technology.
Reset to factory default |
There is a button on PSM08.1. Pressing button for about 5 seconds.2. IDs are excluded and all settings will reset to factory default.Notice: Use this procedure only in the event that the primary controller is lost or otherwise inoperable. |
Inclusion |
There is a button on PSM08.1. Have Z-WaveController entered inclusion mode.2. Pressing button once to enter the inclusion mode.3. After add successful, the device will wake to receive the setting command from Z-Wave Controller about 20 seconds. |
Exclusion |
There is a button on PSM08.1. Have Z-WaveController entered exclusion mode.2. Pressing button once to enter the exclusion mode. |
NIF |
XXXNIF |
Wakeup |
There is a button on PSM08.Press the button once, the device will awake 10 seconds. |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
1 |
Z-Wave Plus Lifeline |
Technical Data
Hardware Platform |
SD3502 |
Device Type |
Notification Sensor |
Network Operation |
Reporting Sleeping Slave |
Firmware Version |
HW: 1 FW: 1.02 |
Z-Wave Version |
6.61.00 |
Certification ID |
ZC10-18046096 |
Z-Wave Product Id |
0x013C.0x0002.0x0036 |
Sensors |
Open/Closed (Binary) |
Supported Notification Types |
Access Control |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |