This is a
- If Inclusion Process is successful, Green led will turn off.
The Smart Smoke Alarm adopts Z-Wave protocol, when the sensor detects smoke to the set level, it will issueacoustic-optic alarm to alert the users and also send alarm notifications to gateway immediately.Its suitable to be installed in living room, office,warehouse,and etc.
- Flat ceiling mounting
The preferred location to install smoke sensor is in the centre of the ceiling, because smoke, heat and combusible products rise to ceiling and will laterally spread. Keep at least 30 cm distance from lights or decoration and at least 17cm away from walls and corners.
- Sloping ceiling mounting
If ceiling is sloping, please install the smok sensor at horizontal distance 90 cm away from the ceiling top.
Installation guide
- Anticlockwise rotation the bracket out from the installation base.
- Fixed the bracket intoceiling using srews.
- Remove the double-sided adhersive and stickalarm into ceiling
- Remove the battery insulating strip to make detector on power and clockwise rotating alarm into bracket.
Reset to factory default | - Long press Net-Button while installing batteries in HS1SA-Z. - Device Reset Locally notification is Transmitted. |
Inclusion | - Press the Net-Button 3 times within 1.5s, Green LED is Blinking 3 times within 1 second. - If Inclusion Process is successful, Green led will turn off. |
Exclusion | - Press the Net_Button 3 times within 1.5s - If Exclusion Process is successful, Green led is Blinking 6 times, then turn off. |
NIF | Press network button once. |
Wakeup | -Wake up Notification is transmitted every 24 hours by default. |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | This is Lifeline association group, Including command classes: Battery report, Notification report, and Device Reset Locally notification |
2 | 5 | This is Root Device group,The Sensor sends a Basic Set command to directly trigger devices (like a light, switch, etc.) in response to events. The value of the Basic Set command (e.g. Siren trigger) is configured usingsmoke or no smoke. |
Dimensions | d= 48 x 52 mm |
Weight | 51 gr |
Hardware Platform | ZM5202 |
EAN | 6971348970444 |
IP Class | IP 20 |
Voltage | 3V |
Device Type | Notification Sensor |
Network Operation | Reporting Sleeping Slave |
Z-Wave Version | 6.71.03 |
Certification ID | ZC10-18076198 |
Z-Wave Product Id | 0x0260.0x8002.0x1000 |
Firmware Updatable | Updatable by Manufacturer |
Supported Notification Types | Emergency AlarmSmoke Alarm |
Color | White |
Communications Protocol | Z-Wave Serial API |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |