This is a
Follow the instructions in the host application that this product is used with.
The Stick is a USB v2.0 full speed low power CDC-ACM compliant Z-Wave adapter in a thumb drive form factor. The Stick can act as a Z-Wave Controller when its connected to a host like PC, MAC or Gateway (some in the market) etc. With a certain program installed on the PC, it can add or remove devices in or from a network
Reset to factory default | Follow the instructions in the host application that this product is used with. |
Inclusion | Follow the instructions in the host application that this product is used with. |
Exclusion | Follow the instructions in the host application that this product is used with. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Z-Wave Plus Lifeline |
As long as this device is not included into a Z-Wave network of a different controller it is able to manage its own Z-Wave network as primary controller. As a primary controller the device can include and exclude other devices in its own network, manage associations, and reorganize the network in case of problems. The following controller functions are supported:
Communication between two Z-Wave devices only works if both belong to the same wireless network. Joining a network is called inclusion and is initiated by a controller. The controller needs to be turned into the inclusion mode. Once in this inclusion mode the other device needs to confirm the inclusion - typically by pressing a button.
If current primary controller in your network is in special SIS mode this and any other secondary controller can also include and exclude devices.
To become primary a contoller have to be resetted and then include a device.
Follow the instructions in the host application that this product is used with.
The primary controller can exclude devices from the Z-Wave network. During exclusion the relationship between the device and the network of this controller is terminated. No communication between the device and other devices still in the network can happen after a successful exclusion. The controller needs to be turned into the exclusion mode. Once in this exclusion mode the other device needs to confirm the exclusion - typically by pressing a button.
Attention: Removing a device from the network means that it is turned back into factory default status. This process can also exclude devices from it's previous network.
Follow the instructions in the host application that this product is used with.
Hardware Platform | ZM5101 |
Device Type | N/A - Hardware Device |
Network Operation | N/A - Hardware Device |
Firmware Version | HW: 0 FW: ERROR |
Z-Wave Version | 6.81.01 |
Certification ID | ZC10-18116302 |
Color | White |
Communications Connections | USB (Universal Serial Bus) |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |