Quickstart
This is a
secure
Notification Sensor for XXXQFrequencyName.
To run this device please make sure the internal battery is fully charged.
To add this device to your network execute the following action:
-Click [Add] icon in Z-Wave Controller.-Press the Net_Button 3 times within 1.5s, Green LED is Blinking 3 times within 1 second.-If Inclusion Process is successful, Green LED will turn off.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Carbon monoxide(CO) is a dangerous poison.It isa colorless, odorless and tasteless gas. CO gasis generated by combustion of carbonaceousmaterials,namely,when not enough oxygen isavailable.This device is intended for use within privatehousing.It is suitable neither for commercial orindustrial applications nor for use on recreationalcraft or commercial vessels.
Reset to factory default |
Long press Net_Button at least 10 seconds in the product. -Device Reset Locally notification is Transmitted-The green LED stays on for 2 seconds and then goes off.Please use this procedure only when the network primary controller is missing or otherwiseinoperable. |
Inclusion |
-Click [Add] icon in Z-Wave Controller.-Press the Net_Button 3 times within 1.5s, Green LED is Blinking 3 times within 1 second.-If Inclusion Process is successful, Green LED will turn off. |
Exclusion |
-Click [Remove] icon in Z-Wave Controller.-Press the Net_Button 3 times within 1.5s -If Exclusion Process is successful, Green LED is Blinking 6 times, then turn off. |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Association group 1: Lifeline association group- Maximum supported node is 5.Include command classes: Battery report, Notification report, and Device Reset Locally notification. |
2 |
5 |
Association group 2: Root Device group(Basic set)- Maximum supported node is 5.TheSensorsendsaBasicSetcommandtodirectlytriggerdevices(likealight,switch,etc.)inresponsetoevents.ThevalueoftheBasicSetcommand(e.g.Sirentrigger)isconfiguredusingCOornoCO |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Notification Sensor |
Network Operation |
Reporting Sleeping Slave |
Firmware Version |
HW: 255 FW: 2.00 |
Z-Wave Version |
6.71.03 |
Certification ID |
ZC10-19016358 |
Z-Wave Product Id |
0x0260.0x8012.0x1000 |
Communications Protocol |
Z-Wave Serial API |
Supported Notification Types |
CO Alarm |
Color |
White |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |