Quickstart
This is a
secure
Light Dimmer Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1. Put the controller into INCLUSION mode. Follow the instructions provided by the controller manufacturer.2. Touch and hold at the center of touch area for more than 5 seconds. Indication LED blinks blue. At this point release the key, the touch dimmer switch start inclusion process.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Featuring a stunning glass face with an advanced capacitive touch sensor, all you need to do is just use a finger for full dimming control and for turning your lights on and off. Tap the back-lit touch button on the panel to switch on or off, and long-press the same button to smoothly dim the lights. This 1 Touch Panel Dimmer ensures that the brightness intensity set is achieved without any loss. The Hogar 1 Touch Panel Dimmer can operate either independently or as a part of the Hogar smart home automation system, and even with any other certified Z-Wave home automation system. Its operating capabilities include a bi-stable mode, a relay mode or touch pulse mode for scene control with a maximum load current of 3 amp. It communicates with the Hogar smart home automation system using the Z-Wave wireless communication protocol.
| Reset to factory default |
1. Press the config button 5 time, Indication LED lights will blinks red in color, touch dimmer switch will start local reset. Touch dimmer switch will erase network inclusion state after local reset.Please use this procedure only when the network primary controller is missing or otherwise inoperable. |
| Inclusion |
1. Put the controller into INCLUSION mode. Follow the instructions provided by the controller manufacturer.2. Touch and hold at the center of touch area for more than 5 seconds. Indication LED blinks blue. At this point release the key, the touch dimmer switch start inclusion process. |
| Exclusion |
1. Put the controller into EXCLUSION mode. Follow the instructions provided by the controller manufacturer.2. Touch and hold at the center of touch area for more than 5 seconds. Indication LED blinks blue. At this point release the key, the touch dimmer switch start exclusionprocess. |
| NIF |
XXXNIF |
| Wakeup |
XXXWakeupDescription |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
3 |
Name: Lifeline Command:Device Reset Locally Notification - Switch Multilevel Report |
Technical Data
| Hardware Platform |
ZM5202 |
| Device Type |
Light Dimmer Switch |
| Network Operation |
Always On Slave |
| Firmware Version |
HW: 255 FW: 2.50 |
| Z-Wave Version |
6.81.01 |
| Certification ID |
ZC10-19046453 |
| Z-Wave Product Id |
0x0293.0x0003.0x4410 |
| Firmware Updatable |
|
| Neutral Wire Required |
ok |
| Electric Load Type |
|
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |
