Aeotec
Aeotec Radiator Thermost
SKU: 4251295701387
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
With the Aeotec Radiator Thermostat you get many functions. It regulates the room temperature to your comfort. For the best use it is equipped with FLiRS (Frequently Listening Receiver Slave) and reacts immediately to incoming commands of the Z-Wave controller. Furthermore the device is able to be connected to an external Z-Wave temperature sensor. Because of that the thermostat refers to the temperature of the external sensor, which can be placed in the middle of the room. The display of the thermostat has a background light and has a big LCD screen. Besides you can also lock the local buttons as a child protection.The multicolor LED of the central button allows a intuitive usability because the User is invited to follow the instruction based on the blinking LED of the middle butto. The TRV can either be used as heating thermostat or as a actuator depending on the configuration of the device. The measured temperature or the position of the actuator of the thermostat are transfered to the Z-Wave gateway.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 1 | Lifeline group to Gateway |
Configuration Parameters
Parameter 1: LCD invert
Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Normal orientation |
| 1 | LCD content inverted |
Parameter 2: LCD Timeout
Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | LCD always on |
| 5 - 30 | LCD timeout in seconds |
Parameter 3: Backlight
Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | Backlight disabled |
| 1 | Backlight enabled |
Parameter 4: Battery report
Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | Battery reporting disabled |
| 1 | Battery reporting enabled |
Parameter 5: Measured temperature report
Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Reporting disabled |
| 1 - 50 | Reporting Delta in 1/10 Celcius |
Parameter 6: Valve percentage report
Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Reporting disabled |
| 1 - 100 | Reporting Delta in percent |
Parameter 7: Window open detection
Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Detection disabled |
| 1 - 3 | Sensitivity level |
Parameter 8: Measured temperature offset
Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| -50 - 50 | Offset in 1/10 Celcius |
| -128 | Temperature is supplied externaly |
Technical Data
| Hardware Platform | ZM5202 |
| Device Type | Thermostat - HVAC |
| Network Operation | Listening Sleeping Slave |
| Firmware Version | HW: 49 FW: 0.16:00.10 |
| Z-Wave Version | 6.71.01 |
| Certification ID | ZC10-19086734 |
| Z-Wave Product Id | 0x0371.0x0002.0x0015 |
| Thermostat HVAC Systems Supported | Heat Only |
| Thermostat Modes | Energy Save Heat |
| Color | White |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |