Philio
CO2 Sensor-A
SKU: PAT12
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The PAT12 sensor is easy to use and very convenient for your home. Just set the sensor on the wall in the rooms you would like to control, and you are ready to go. Moreover, the PAT12 can be integrated to other Z-Wave certified devices, and controlled with Philio app Home Mate 2. You can now protect your family and your business and make sure that air you are breathing is safe. Set up your PAT12 to send regular notifications and take control even when not at home.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | Used for returned events. |
Configuration Parameters
Parameter 1: Auto report CO2 Concentra- tion time
Units of 1 minute. Size: 2 Byte, Default Value: 60
| Setting | Description |
|---|---|
| 1 - 32767 | Units of 1 minute. |
Parameter 2: CO2 Concentration differen- tial report
Units of 1 %.0 means turn off the report Size: 1 Byte, Default Value: 10
| Setting | Description |
|---|---|
| 1 - 100 | Units of 1 % |
Parameter 3: Baseline level 1
Units of 100 ppm.0 means turn off the report Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 - 50 | Units of 100 ppm. |
Parameter 4: Baseline level 2
Units of 100 ppm.0 means turn off the report Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 - 50 | Units of 100 ppm. |
Parameter 5: Baseline level 3
Units of 100 ppm.0 means turn off the report Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 - 50 | Units of 100 ppm. |
Parameter 6: Baseline level 4
Units of 100 ppm.0 means turn off the report Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 - 50 | Units of 100 ppm. |
Parameter 7: Baseline level 5
Units of 100 ppm.0 means turn off the report Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 - 50 | Units of 100 ppm. |
Technical Data
| Hardware Platform | SD3502 |
| Device Type | Notification Sensor |
| Network Operation | Always On Slave |
| Firmware Version | HW: 1 FW: 1.02:01.02 |
| Z-Wave Version | 6.81.03 |
| Certification ID | ZC10-19096749 |
| Z-Wave Product Id | 0x013C.0x0002.0x006B |
| Firmware Updatable | Not Updatable |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |