Quickstart

This is a secure Repeater for XXXQFrequencyName. To run this device please make sure the internal battery is fully charged. SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code present on the product with a controller providing SmartStart inclusion. No further action is required and the SmartStart product will be added automatically within 10 minutes of being switched on in the network vicinity. Z-Wave SmartStart utilizes the DSK of the device to enhance and simplify the inclusion process. DSK is Device Specific Key used for authentication. The DSK information is stored in the QR code format that is printed on a label and adhered to the front side of the device, as example shown on the right hand side.
- Scan the QR Code sticker on the Router to obtain DSK and transfer to the Z-Wave gateway.
- Plug the Router into a power outlet, a SmartStart inclusion request will be automatically sent to the gateway.
- The gateway will automatically include the device upon recognition of the device by matching the inclusion request with the DSK obtained

NOTE
- The DSK of the device is used only during inclusion.
- The DSK can be read without the Router powered ON, so it is possible to prepare the gateway to include the device prior to powering up the Router.

Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

The Heatit Z-Repeater Dual USB 2A is a multifunctional AC Z-Wave range extender with two USB power adapters that allow you to charge two devices at the same time. Ideal for extending the Z-Wave signal to areas with blind spots - a solution for anyone experiencing poor wireless connectivity.With the rechargeable backup batteries, the device will still be able to operate for up to 6 hours after a power failure. Important battery-operated units such as door locks, smoke detectors and burglary alarms will still work during a blackout.

Product Usage

Parts Identification

1. LED Indicator (Inside) The LED Indicator is located inside the cover and only visible when activated

- 2 flashes: The Router is powered on.

- 3 flashes: The Router is Factory reset.

2. USB Ports The USB ports provide 5V DC 2A power output to connected USB cable.
3. Interchangeable Plug The plug type may be changed according to regional requirement.
4. Function Button

- Press 3 times within 1.5 seconds to transmit a learn code.

- Press and hold for 10 seconds to factory reset.

- Press once to send battery percentage report to the Z-Wave network.

Reset to factory default	Press and hold the Function Button for 10 seconds to factory reset.
Inclusion	Within 1.5 seconds, press the Function Button 3 times
Exclusion	Within 1.5 seconds, press the Function Button 3 times
NIF	XXXNIF
Wakeup	XXXWakeupDescription
Protection	XXXProtection
FirmwareUpdate	XXXFirmwareUpdate
SetAssociation	XXXSetAssociation

Association Groups:

Group Number	Maximum Nodes	Description
1	1	Lifeline

Technical Data

Hardware Platform	ZM5202
EAN	7071236015352
IP Class	IP 20
Voltage	230V
Device Type	Repeater
Network Operation	Always On Slave
Z-Wave Version	6.81.06
Certification ID	ZC10-20036881
Z-Wave Product Id	0x019B.0x0003.0x3600
Frequency	Europe - 868,4 Mhz
Maximum transmission power	5 mW

Heatit (Thermo-Floor)