Quickstart
This is a
secure
Notification Sensor for XXXQFrequencyName.
To run this device please make sure the internal battery is fully charged.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Product Description
The SD-29 is a wirelessly operated photo-electronic Smoke Detector designed to operate with any Z-Wave enabled controller devices; it also features smoke detecting, temperature sensing and IR detection. The Smoke Detectors alarm situations, battery condition, operating conditions, supervisory data and general fault information are sent to the Z-Wave Gateway/Control Panel wirelessly. The device is also serially connected with other sensors in the Z-Wave gateway to serve as an extra siren.
Reset to factory default |
XXXResetDescription |
Inclusion |
XXXInclusionDescription |
Exclusion |
XXXExclusionDescription |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
1 |
Lifeline group - Battery CC (COMMAND_CLASS_BATTERY)Notification CC,V4 (COMMAND_CLASS_NOTIFICATION)SensorMutilevel CC, V4 (COMMAND_CLASS_SENSOR_MULTILEVEL)Device Reset Locally CC (COMMAND_CLASS_DEVICE_RESET_LOCALLY) |
2 |
1 |
Basic CC (COMMAND_CLASS_BASIC)*. When the Smoke Detector is active, it will send Basic Set (0xFF) in Group 2. *. When the Smoke Detector is restored, it will send Basic Set (0x00) in Group 2. |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Notification Sensor |
Network Operation |
Listening Sleeping Slave |
Firmware Version |
HW: 255 FW: 4.01 |
Z-Wave Version |
6.81.06 |
Certification ID |
ZC10-20046908 |
Z-Wave Product Id |
0x018E.0x0003.0x0018 |
Firmware Updatable |
Updatable by Consumer by RF |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |