Enbrighten
In-Wall Tamper Resistant Smart Outlet
SKU: 55256/ZW1002
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Transform any home into a smart home with the GE/Enbrighten Z-Wave Tamper Resistant Smart Outlet. The GE/Enbrighten Z-Wave Tamper Resistant Smart Outlet enables wireless control of on/off functions from the Z-Wave controlled outlet, and is compatible with incandescent, LED, Xenon, Halogen, fluorescent and compact fluorescent bulbs. The tamper resistant duplex receptacle includes a blue LED indicator light to easily locate the receptacle in a dark room. The receptacle replaces your current electrical outlet, uses your existing wiring and provides a Z-Wave enabled outlet for the lamp or appliance that you would like to control and a standard pass-through AC outlet for other electrical appliances. Take control of your home lighting with Jasco Z-Wave Smart Lighting Controls!
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | Z-Wave Plus Lifeline |
| 2 | 5 | Supports Basic Set and is controlled with the local load |
| 3 | 5 | Supports Basic Set and is controlled by pressing the On or Off button |
Configuration Parameters
Parameter 3: LED Light
Settings for control of the LED light/ guidelight Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | LED On when load is Off, Led Off when load is On |
| 1 | LED On when load is On, LED Off when load is Off (Default) |
| 2 | LED always off |
Technical Data
| Hardware Platform | ZM5202 |
| Device Type | On/Off Power Switch |
| Network Operation | Always On Slave |
| Firmware Version | HW: 255 FW: 5.51 |
| Z-Wave Version | 6.82.00 |
| Certification ID | ZC10-20076950 |
| Z-Wave Product Id | 0x0063.0x4952.0x3234 |
| Electric Load Type | |
| Switch Type | Push Button Illuminated |
| Neutral Wire Required | ok |
| Firmware Updatable | Updatable by Consumer by RF |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |