Quickstart
This is a
secure
Notification Sensor for XXXQFrequencyName.
To run this device please make sure the internal battery is fully charged.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Product Description
The ZD2106 Door and Window sensor is used in any Z-Wave network to detect the opening or closing of a door or window.The Slim design is very attractive.The ZD2106 is powered by one coin battery (CR2032), the battery life is more than 3 years. The ZD2106 features tamper-proof switch,low battery warning and can be firmware updated over the air.
Reset to factory default |
XXXResetDescription |
Inclusion |
XXXInclusionDescription |
Exclusion |
XXXExclusionDescription |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
* Group 1 = Lifeline |
2 |
5 |
* Group 2 = On/Off Control |
Technical Data
Hardware Platform |
ZGM130 |
Device Type |
Notification Sensor |
Network Operation |
Reporting Sleeping Slave |
Firmware Version |
HW: 9 FW: 32.04 |
Certification ID |
ZC12-20040050 |
Z-Wave Product Id |
0x0109.0x2001.0x01D1 |
Color |
White |
Firmware Updatable |
Updatable by Manufacturer Representative |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |