Ring
Range Extender
SKU: Range Extender v2
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Ring Alarm Range Extender is a wireless repeater for the Ring Alarm system which helps to improve the range and reliability of the Ring Alarm network by listening for and repeating network communication between the Ring Alarm Base Station and other Ring Alarm end devices. After installing the Range Extender and setting up the Range Extender in the Ring app, the devices added to Ring Alarms network can utilize the Range Extenders routing and repeating to communicate effectively with the Base Station. The Ring Alarm Base Station is required to enable Range Extender features and functions within the Ring app.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | This is the Lifeline group and the following are the supported command class - 1. Notification Reporta. See notification CC section for notifications that are sent2. Battery Report3. Device Reset Locally Notification |
Configuration Parameters
Parameter 1: Hearbeats
This parameter is the number minutes between heartbeats. Heartbeats are automatic battery reports on a timer after the last event. Size: 1 Byte, Default Value: 70
| Setting | Description |
|---|---|
| 1 - 70 | This parameter is the number of minutes between heartbeats. |
Parameter 2: Application Retries:
Number of application level retries attempted for messages either not ACKed or messages encapsulated via supervision get that did not receive a report. Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 - 5 | This parameter is the Number of application level retries. |
Parameter 3: Application Level Retry Base Wait Time Period:
The number base seconds used in the calculation for sleeping between retry messages. Size: 1 Byte, Default Value: 5
| Setting | Description |
|---|---|
| 1 - 60 | This parameter is the number base seconds used in the calculation for sleeping between retry messages. |
Parameter 4: LED Indicator
Allows LED indications on the device to be turned on or off Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 - 2 | This parameter is the LED indications on the device to be turned on or off |
Parameter 5: Supervisory Report Timeout
The number of milliseconds waiting for a Supervisory Report response to a Supervisory Get encapsulated command from the sensor before attempting a retry. Size: 2 Byte, Default Value: 1500
| Setting | Description |
|---|---|
| 500 - 5000 | The number of milliseconds waiting fornumber of milliseconds waiting for a Supervisory Report response to a Supervisory Get . |
Technical Data
| Hardware Platform | EFR32Z |
| Device Type | Repeater |
| Network Operation | Always On Slave |
| Firmware Version | HW: 1 FW: 1.10 |
| Z-Wave Version | 7.12.1 |
| Certification ID | ZC12-20050059 |
| Z-Wave Product Id | 0x0346.0x0401.0x0301 |
| Color | White |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |