Aeotec
Z-PI7 US
SKU: ZWA025
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The Z-PI7 turns every Raspberry PI or Orange Pi into an Z-Wave 700 series based Smart Home Gateway.The Z-Pi 7 is attached to the GPIOs of the host, such as a PC,as your primary Z-Wave controller. Then it can be used with your any automation software as long as it supports the Z-Wave Serial Bridge API.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Technical Data
| Hardware Platform | EFR32Z |
| Device Type | Hardware Device |
| Network Operation | Hardware Device |
| Firmware Version | HW: 0 FW: ERROR |
| Z-Wave Version | 7.11.0 |
| Certification ID | ZC12-20090121 |
| Communications Protocol | Manufacturer Proprietary Protocol |
| Firmware Updatable | Not Updatable |
| Controller Supports Multiple Z-Wave Interfaces | ok |
| Color | Antique Brass |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |