Square D
Z-Wave Plus Switch
SKU: SQR14102**Z (** means color code)
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The Square D 15 Amp Z-Wave Switch Single Pole/3-WAY Energy Monitoring is the professionals choice for secure reliable lighting control. Sensitive enough to control the low wattage demands of a single LED yet as well as the demands of bright outdoor lighting.Perfect for monitoring energy usage in bedrooms where the switch controls the receptacles. It works with any Z-Wave hub and can be grouped with up to 5 other Z-Wave Plus devices.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | Lifeline: Send device reset locally notificationStatusReport: On/Off status reportPowerReport: Power metering report |
| 2 | 5 | Sends Basic Set to associated devices,when press ON Button and OFF Button atsame time. |
Configuration Parameters
Parameter 1: LED indicator Status
Synchronization of load power and LED indicator. Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | Power On, LED Off; Power Off, LED On |
| 1 | Power On, LED On;Power Off, LED Off |
Parameter 2: Delayed OFF Time
Delay off means when users pressbutton to turn off the load,theres a reaction time. Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|
Parameter 3: Power On Status
When the device is powered on, theinitial status. Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 1 - 0 | Off |
| 2 - 0 | On |
| 3 - 0 | Last State |
Parameter 4: Child Lockout Enable
Child lockout feature can enabled anddisabled local control. Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Disable |
| 1 - 0 | Enable |
Technical Data
| Hardware Platform | ZGM130 |
| Device Type | Binary Switch |
| Network Operation | Always On Slave |
| Firmware Version | HW: 1 FW: 1.17 |
| Z-Wave Version | 7.13.6 |
| Certification ID | ZC12-21030193 |
| Z-Wave Product Id | 0x0447.0x000E.0x1106 |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |