This is a
Make any outlet smarter with the new IQ Outlet using the 700 series Z-Wave module- Turns ON/OFF incandescent, CFL, or LED lamps, and AC operated electrical appliances- 700 Series Z-Wave module- Energy monitoring supported- LED to indicate ON/OFF status- Controls appliances up to 15A- Z-Wave Plus Certified with S2 security and SmartStart (QR code with Z-Wave DSK included)- Grounded 3-pin AC power receptacle to enhance safety- Safety tab to secure to outlet- Compact design - does not block the 2nd AC outlet- Over-The-Air firmware upgrade available, if supported by controller- Supports Network Wide Inclusion (inclusion through a repeater), if supported by controller.- Functions as a Z-Wave signal repeater
Reset to factory default | XXXResetDescription |
Inclusion | XXXInclusionDescription |
Exclusion | XXXExclusionDescription |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | IQ Outlet supports Group 1 for lifeline communication |
2 | 5 | The devices in Association Group 2 can be controlled (on/off) by single pressing the button using Basic Set |
When value = 0, the LED indicator will be OFF when the connected appliance is ON, and the LED indicator will be ON when the connected appliance is OFF.If value = 1, the LED indicator will be OFF when the connected appliance is OFF, and the LED indicator will be ON when the connected appliance is ON.If value = 2, the LED indicator will be always OFF regardless of the load status. Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 - 2 | When value = 0, the LED indicator will be OFF when the connected appliance is ON, and the LED indicator will be ON when the connected appliance is OFF. If value = 1, the LED indicator will be OFF when the connected appliance is OFF, and the LED indicator will be ON when the connected appliance is ON. If value = 2, the LED indicator will be always OFF regardless of the load status. |
0 = Disable energy monitoring, default 1 - 255 = Reporting interval (minutes) Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 - 255 | 0 = Disable energy monitoring, default 1 - 255 = Reporting interval (minutes) |
Hardware Platform | ZGM130 |
Device Type | Binary Switch |
Network Operation | Always On Slave |
Firmware Version | HW: 1 FW: 7.08 |
Z-Wave Version | 7.13.7 |
Certification ID | ZC12-21030207 |
Z-Wave Product Id | 0x012A.0x4744.0x3033 |
Color | White |
Outdoor Use | ok |
Firmware Updatable | Updatable by Consumer by RF |
Electric Load Type | FluorescentIncandescentInductive (e.g. Motor)LED |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |