Quickstart
This is a
secure
Binary Switch DT for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Product Description
This in-wall switch module is a transceiver which is a Z-Wave Plus TMenabled device and is fully compatible with any Z-Wave TMenabled network. Mini size design let the module can easily hide itself into the wall box and that will be good for the house decoration.
| Reset to factory default |
XXXResetDescription |
| Inclusion |
XXXInclusionDescription |
| Exclusion |
XXXExclusionDescription |
| NIF |
XXXNIF |
| Wakeup |
XXXWakeupDescription |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
5 |
|
| 2 |
5 |
|
| 3 |
5 |
|
Technical Data
| Hardware Platform |
ZGM130S037HGN2 / ZGM130S037HGN1 |
| Device Type |
Binary Switch DT |
| Network Operation |
Always On Slave |
| Firmware Version |
HW: 01 FW: 02.00 |
| Z-Wave Version |
7.15.1 |
| Certification ID |
ZC14-21110012 |
| Color |
White |
| Firmware Updatable |
Updatable by Consumer by RF |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |
