Jasco Products Company
Plug-in Smart Switch, Dual Outlet with Simultaneous Control
SKU: 14309
Quickstart
This is a
1. Follow the instructions for your Z-wave certified controller to include the device to the Z-wave network.2. Once the controller is ready to include your smart switch, single press and release the manual/program button on the smart switch to include it in the network.3. Once your controller has confirmed that the smart switch has been included, refresh the Z-wave network to optimize performance.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Transform any home into a smart home with the Jasco Z-Wave Smart Lighting Control Fluorescent Light and Appliance Module. The lighting control enables wireless control of on/off functions for standard table and floor lamps, and is compatible with incandescent, LED, Xenon, Halogen, fluorescent and compact fluorescent bulbs. Easily controlled by your mobile device or computer using any Z-Wave certified gateway, the space-saving horizontal module plugs into a standard wall receptacle without blocking the second outlet or obstructing placement of furniture. It provides a Z-Wave enabled outlet for the lamp or appliance that you would like to control and a regular pass-through AC outlet for other electrical appliances. Perfect for plug-in fans, heaters, lamps and more! Take control of your home lighting with Jasco Z-Wave Smart Lighting Controls!
| Reset to factory default | 1. If plugged in, unplug the Switch from the receptacle.2. Press and hold the top button for at least 3 seconds while you plug the switch into a receptacle.Note: This should only be used in the event your networks primary controller is missing or otherwise inoperable. |
| Inclusion | 1. Follow the instructions for your Z-wave certified controller to include the device to the Z-wave network.2. Once the controller is ready to include your smart switch, single press and release the manual/program button on the smart switch to include it in the network.3. Once your controller has confirmed that the smart switch has been included, refresh the Z-wave network to optimize performance. |
| Exclusion | 1. Follow the instructions for your Z-wave certified controller to exclude a device from the Z-wave network.2. Once the controller is ready to Exclude your device, press and release the manual/program button on the smart switch to exclude it from the network. |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 1 | Z-Wave Plus Lifeline |
Configuration Parameters
Parameter 3: LED Light
LED Light Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 1 | To make the LED turn ON when the light is turned ON, change parameter 3s value to 1. |
| 2 | To turn the LED OFF at all times, change parameter 3s value to 2 |
| 0 | Default |
Technical Data
| Hardware Platform | ZM5202 |
| Device Type | On/Off Power Switch |
| Network Operation | Always On Slave |
| Firmware Version | HW: 255 |
| Z-Wave Version | 6.51.06 |
| Certification ID | ZC10-15070016 |
| Z-Wave Product Id | 0x0063.0x5052.0x3035 |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |