Quickstart
This is a
Door Lock Keypad for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
To include our device into a controller.1.Perform 'Include' on the controller.2.From the lock's main menu item "7.Zwave", select the "ZwaveInclusion" by using the arrow keys to scroll to it and then pressing 'M' to select it. After a few seconds, you should see "Success" on the lock.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
The RTS-PZ is perfect for security-sensitive business and government environments. Set access control rights for each individual user to each individual lock and upload these access rights in seconds. You can register users as PIN-code only on any lock or group of locks you define. The combination of large user capacity, audit trails, built-in scheduling system and weather- proof design makes this system unequaled in value compared to other products currently available.
| Reset to factory default |
If your controller fails or is replaced or if you need to perform a Factory reset on the device so that an inclusion may be performed again or with a new controller, Factory reset can be done on the device by selectingHard Reset from theMain Menu on devices display and pressing the 'M' button.When prompted to reset press the 'M' button on the unit and the device will display initializing.Once the reset is complete the display will return to the Main Menu. Note: When a Hard Reset is completed, the zwave node id is initialized to 0 and the device can't be controlled by zwave.In order to control the device again, the controller needs to include the device on zwave network. |
| Inclusion |
To include our device into a controller.1.Perform 'Include' on the controller.2.From the lock's main menu item "7.Zwave", select the "ZwaveInclusion" by using the arrow keys to scroll to it and then pressing 'M' to select it. After a few seconds, you should see "Success" on the lock. |
| Exclusion |
To exclude our device from a controller .1.Perform 'Exclude' on the controller.2.From the lock's main menu item "7.Zwave", select the "ZwaveExclusion" option by using the arrow keeys to scroll to it and then pressing 'M' to sleect it. After a few seconds, you should see "Success" on the lock. |
| NIF |
XXXNIF |
| Wakeup |
When accessing the lock simply press the # button to scan a fingerprint or enter your pincode directly then press the * button twice.To access the Main Menu press the M button on the inside unit.Any Z-wave communication will wake the unit and then execute any command from a paired controller. |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
5 |
Z-Wave Plus Lifeline |
Technical Data
| Hardware Platform |
ZM5202 |
| Device Type |
Door Lock Keypad |
| Network Operation |
Listening Sleeping Slave |
| Firmware Version |
10 |
| Z-Wave Version |
6.51.06 |
| Certification ID |
ZC10-15110002 |
| Z-Wave Product Id |
0x0217.0x0900.0x0001 |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |