This is a
This motion detector (PIR = passive infrared receiver) of the HomePro system detects the presence of a person in a room. The units send information to a controller or any other associated Z-Wave device. Up to 4 devices can be controlled from this unit. The sensor is a battery-powered device, which is in sleeping state unless an action is detected. After a programmable sleeping time the device wakes up and sends a status information. After this the unit goes back to sleeping modus. Batteries can be changed without unscrewing the device from the door or frame. The unit will give a visual warning on the device and sends a warning to the Z-Wave controller, when batteries need to be replaced.The unit offers a tampering control and sends an alarm message when tampered. The device needs to be included into a Z-Wave network by a remote control or any other Z-Wave controller. For configuration of certain behaviour a static controller such as a PC with home automation software or a gateway is recommended.
Three different types of operation are possible:
Technical Data
"
Reset to factory default | XXXResetDescription |
Inclusion | XXXInclusionDescription |
Exclusion | XXXExclusionDescription |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Dimensions | 0.0000000x0.0000000x0.0000000 mm |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |