Quickstart

This is a Z-Wave Device for XXXQFrequencyName. To run this device please connect it to your mains power supply.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

This device is a switch plug-in and is used between a standard Schuko wall outlet and lamps connected to a wall outlet by cable. The unit is rated IP 20 and can therefore be used in dry environments only. The unit is included into a Z-Wave network by a remote control, PC software or any other kind of Z-Wave controller. It switches all kind of loads. Local operation is possible by pressing the button on the device.

Technical Data:

 

  • Power rating: 230V, 50 Hz
  • Maximum load: 10A
  • Wireless behaviour: receiver
  • Z-Wave type: slave
  • Distance: up to 100 m outdoor, up to 30 m in buildings
  • Display: -
  • Local Interaction: one button for switching, inclusion, exclusion and association
  • Power supply: via 230 V power

"

Reset to factory default XXXResetDescription
Inclusion XXXInclusionDescription
Exclusion XXXExclusionDescription
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Dimensions 0.0000000x0.0000000x0.0000000 mm
Frequency Europe - 868,4 Mhz
Maximum transmission power 5 mW
EuropeZ-Wave Device