Aeotec
Range Extender 6 (E, F and UK)
SKU: AEOEZW117
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Aeotec Range Extender is a Z-Wave mesh network repeater which can extend the range of communication between Z-Wave products and assist other devices to reach each other in your Z-Wave network.
The Range Extender can also communicate securely via AES 128 wireless Z-Wave commands and supports Over-The-Air (OTA) firmware upgrades.
| Reset to factory default | Press and hold the Z-Wave Button for 20 seconds and then release it. |
| Inclusion | 1. Install the device according to the instructions 2. Press the button on Range Extender 6 once. |
| Exclusion | 1. Press the button on Range Extender 6 once. |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Technical Data
| Dimensions | 45 x 45 x 60 mm |
| Weight | 39 gr |
| Hardware Platform | ZM5101 |
| EAN | 1220000016149 |
| IP Class | IP 20 |
| Voltage | 230 V |
| Device Type | Z-Wave Repeater |
| Firmware Version | 01.01 |
| Z-Wave Version | 04.22 |
| Certification ID | ZC10-16095248 |
| Z-Wave Product Id | 0x0086.0x0004.0x0075 |
| Color | White |
| Firmware Updatable | Updatable by Consumer by RF |
| Frequency | Europe - 868,4 Mhz |
| Maximum transmission power | 5 mW |