This is a
A single click on the Z-Wave switch will confirm Inclusion and Exclusion.
This device take existing Z-WAVE signal, repeat and send it to a longer range where it is too far away for the controller (supporting FLiRS devices). Due to a special antenna amplifier the operating range will be up to 200 meters when installed correctly.
Plug the edvice into a free plug socket.
The LED will blink as long the deivce is not included into a Z-Wave network.
Note: For indoor use only!
After inclusion the LED will stop to blink.
The extender is a passive device, that only extends your Z-Wave network"s range.
Reset to factory default | XXXResetDescription |
Inclusion | single click on the program switch |
Exclusion | single click on the program switch |
NIF | A single click on the program switch will send out a Node Information Frame. |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Dimensions | 0.0460000x0.0460000x0.0580000 mm |
Weight | 38 gr |
EAN | 1220000012660 |
Firmware Version | 00.00 |
Z-Wave Version | 00.00 |
Certification ID | ZC08-14030012 |
Z-Wave Product Id | 0086.0000.0000 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |