Quickstart

This is a On/Off Power Switch for XXXQFrequencyName. To run this device please connect it to your mains power supply. To add this device to your network execute the following action:
1. Put the Z-Wave Controller into inclusion mode.2. Press the link key three times within 1.5 seconds to put the unit into inclusion mode.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from Z-Wave Alliance Product data and may be incomplete. Please refer to the Manufacturers Manual for more information.

Product Description

The In-Wall On/Off Module is a Z-Wave enabled device which is fully compatible with any Z-Wave enabled network.Z-Wave enabled devices displaying the Z-Wave logo can also be used with it regardless of the manufacturer, and ours can also be used in other manufacturers Z-Wave enabled networks.Inclusion of this unit on other manufacturers Wireless Controller menu allows remote operation of the unit and the connected load.Z-Wave node in the system also acts as a repeater, so the RF signal can reach its intended receiver by routing around obstacles and radio dead spots.The In-Wall On/Off Module is designed to control the on/off status of lighting and appliances load in your house.Two sets of dry contacts provide more wiring applications.For security, the unit can detect overheating and will turn off relay automatically to avoid damage.At 230V voltage, this module can support up to 2500W resistive, 1200W incandescent, 700W motor, or 320W (40W*8) fluorescent load.

Reset to factory default (This procedure should only be used when the primary controller is no longer operational.)1.Press the link key three times within 1.5 seconds to put the unit into exclusion mode.2.Within 1 second of step 1, press link key again and hold until LED is off (about 5 sec.).3.Node ID is excluded, and the unit is returned to the factory default state.
Inclusion 1. Put the Z-Wave Controller into inclusion mode.2. Press the link key three times within 1.5 seconds to put the unit into inclusion mode.
Exclusion 1.Put the Z-Wave Controller into exclusion mode.2.Press the link key three times within 1.5 seconds to put the unit into exclusion mode.
NIF XXXNIF
Wakeup NR
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Association Groups:

Group Number Maximum Nodes Description
1 5 Z-Wave Plus Lifeline

Technical Data

Hardware Platform SD3502
Device Type On/Off Power Switch
Network Operation Always On Slave
Firmware Version 02
Z-Wave Version 6.51.02
Certification ID ZC10-14080013
Z-Wave Product Id 0x0060.0x0004.0x0008
Frequency XXfrequency
Maximum transmission power XXantenna
CEPT (Europe)On/Off Power Switch