Quickstart
This is a
Thermostat - HVAC for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1. Put the thermostat in OFF mode (No mode icons are lit).2. Put the Z-Wave controller into add mode. Refer to the controller documentation for more information.3. Press and hold the DOWN button on the thermostat to begin inclusion. Release the button when the RADIO icon lights up.4. When the RADIO icon becomes solid, the thermostat has been added.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
The Building 36 Intelligent Thermostat gives you remote access and control of your thermostat.Enjoy effortless energy management, climate and ambiance control, custom automation and measurable results. Create custom smart schedules that automate your thermostat. Receive critical temperature alerts to know instantly when your thermostat reaches preset limits. Save energy by using location-based automation to have your thermostat adjust itself while you're out.This thermostat is part of an entire ecosystem of home automation products.It was built to provide a single integrated solution to give you more from your connected home.
| Reset to factory default |
Please use this procedure only when your primary controller is missing or otherwise inoperable.1. Put the thermostat in OFF mode (No mode icons are lit).2. Press and hold the UP button to show the firmware versions.3. Once the firmware versions are shown, press and hold the DOWN button to enter RST mode. The thermostat should display "RST". |
| Inclusion |
1. Put the thermostat in OFF mode (No mode icons are lit).2. Put the Z-Wave controller into add mode. Refer to the controller documentation for more information.3. Press and hold the DOWN button on the thermostat to begin inclusion. Release the button when the RADIO icon lights up.4. When the RADIO icon becomes solid, the thermostat has been added. |
| Exclusion |
1. Put the thermostat in OFF mode (No mode icons are lit).2. Press and hold the remove button on the Z-Wave controller. Refer to controller documentation for more information.3. Press and hold the DOWN button on the thermostat to enter exclusion mode.Release the button when the RADIO icon lights up.4. When the RADIOicon becomes solid the thermostat has now been successfully removed from the network. |
| NIF |
XXXNIF |
| Wakeup |
XXXWakeupDescription |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
4 |
Z-Wave Plus Lifeline |
Technical Data
| Hardware Platform |
ZM5202 |
| Device Type |
Thermostat - HVAC |
| Network Operation |
Always On Slave |
| Firmware Version |
1.0 |
| Z-Wave Version |
6.51.02 |
| Certification ID |
ZC10-14120002 |
| Z-Wave Product Id |
0x0190.0x0001.0x0001 |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |