This is a
This sensor monitors leakage and sends an alarm when flooding or leakage is detected. The sensing device can be away up to 3 m from the main device. The unit can be mounted on every flat surface. The installation can be done with screws or double-sided tape.
The ST812 is a battery-powered device, which is in non-operating state unless an action is detected. After a programmable sleeping time the device wakes up and sends status information. After this the unit goes back to non-operating state. Batteries can be changed without unscrewing the device from the door or frame. The unit will give a visual warning on the device and sends a warning to the Z-Wave controller, when batteries need to be replaced. The units send information to a controller or any other associated Z-Wave device. Up to 4 devices can be controlled from this device.
The device needs to be included into a Z-Wave network by a remote control or any other Z- Wave controller. For configuration of certain behavior a static controller such as a PC with home automation software or a gateway is recommended.
We would like to point out that this article is not a new product. The product has got the complete functionality and can be integrated into a Z-Wave Smart Home without restriction.
However, the product may have the following characteristics:
We offer to you a guarantee of 1 year. With a possible return you receive a credit note, there is no exchange of the product.
The picture may not correspond to the scope of delivery of the product.
If you are interested in a larger quantity of used products, please contact your sales representative.
Reset to factory default | XXXResetDescription |
Inclusion | XXXInclusionDescription |
Exclusion | XXXExclusionDescription |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Dimensions | 0.0850000x0.0850000x0.0390000 mm |
Weight | 170 gr |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |