Quickstart

This is a Z-Wave Device for XXXQFrequencyName. To run this device please connect it to your mains power supply.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

The SEC_SRT322 is a system to control warm water heating in general and floor heating installations in particular. It consists of a battery-operated wall thermostat (SEC_SRT321) installed in the room to be controlled and a relay switch (SEC_SSR303) to operate the water boiler. 

Thermostat (Transmitter)
The SRT321 is a battery-operated wall thermostat. Using a big wheel on the device the user can preset the desired target temperature in the room. By verifying the target temperature with the measured real temperature closed to the device the unit decides how to operate a wirelessly attached power switch that is attached to the heater. In parallel a central gateway of Z-Wave control software can set the target temperature using Z-Wave. This enables to realize a time scheduled zone heating. The thermostat itself does not have any internal timers but executes the wireless settings (COMMAND CLASS THERMOSTAT_SETPOINT) and the local setup. The thermostat itself doesn"t own an internal timer.

Controller Unit (Receiver)
The SSR303 is a wirelessly controlled relay switch to operate loads up to 3 A / 230 V. It is used to control warm water boilers or magnet valves. The device can be operated locally using two buttons. A LED indicated the current switching status. The fashionable design of the device allows mounting it on visible positions in the home.

Features:

  • Set consists of SCS321 thermostat and SSR303 relay switch
  • Temperature adjustable via adjusting wheel
  • Controls warm water heating, e.g. floor heating
  • Thermostat with display 
  • Relay switches 230 V loads
  • Max. switch load: 3 A
  • Relay switch with local control buttons
  • Wireless Technology: Z-Wave
  • Dimensions Thermostat SRT321: 87x87x37 mm 
  • Dimensions Controller Unit SSR303: 86x86x30 mm

We would like to point out that this article is not a new product. The product has got the complete functionality and can be integrated into a Z-Wave Smart Home without restriction.

However, the product may have the following characteristics:

  • broken seal,
  • damaged packaging,
  • no original packaging
  • missing accessories,
  • minimal signs of wear,
  • no current software version.

We offer to you a guarantee of 1 year. With a possible return you receive a credit note, there is no exchange of the product.

The picture may not correspond to the scope of delivery of the product.

If you are interested in a larger quantity of used products, please contact your sales representative.

Reset to factory default XXXResetDescription
Inclusion XXXInclusionDescription
Exclusion XXXExclusionDescription
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Dimensions 0.0870000x0.1800000x0.0370000 mm
Weight 275.66 gr
Frequency Europe - 868,4 Mhz
Maximum transmission power 5 mW
EuropeZ-Wave Device