This is a
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
living connect® is a Z-Wave controlled electronic radiator thermostat. It is controlled by either a Z-Wave compatible Controller or a central device called Danfoss LinkTM CC. The Danfoss LinkTM CC can also control hydronic and electrical floor heating and on/off switches in a building. living connect® uses Z-Wave wireless communica-tion technology, is easy to install and is supplied with adapters for all thermostatic valves manu-factured by Danfoss and most other radiator valve manufacturers.
living connect® is battery powered, compact and very easy to operate with only three buttons on the front.
Additionally the temperature can be set wirelessly to a certain setpoint. The device has a scheduler inside that allows to set up to 9 different setpoint for each day of a 7 day week. This means that energy saving is even achieved when the controllingdevice is offline or not working. Local buttons can always overwrite the scheduled setting. living connect® features an open-window function, which closes the valve if the temperature in the room is falling dramatically.
Technical Features
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Here are a few hints for network installation if things dont work as expected.
Dimensions | 0.0000000x0.0000000x0.0000000 mm |
Certification ID | ZC08-11030005 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |