This is a
1.Set primary controller to Include mode2. Press the Install Button
The DB100Z is a battery powered, voltage sensing device that sends out a Notification report when voltage is detected at the sensor inputs.
Reset to factory default | Please only perform a factory reset when the primary controller is missing or inoperable.A factory reset will remove all network settings and configurations. 1. Hold down Install Button for 10 seconds2. Release the Install Button3. When the Status LED begins to blink, the unit has finished restoring configuration |
Inclusion | 1.Set primary controller to Include mode2. Press the Install Button |
Exclusion | 1.Set primary controller to Exclude mode2. Press the Install Button |
NIF | XXXNIF |
Wakeup | When the Install Button is triple-pressed, the device will send a Wakeup Notification report and stay awake for 10 seconds.WAKEUP_INTERVAL_CAPABILITIES_REPORT Min Wake Up Interval :60 seconds Max Wake Up Interval: 86400 seconds Default Wake Up Interval: 25200 seconds Wake Up Interval Step: 60 |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Z-Wave Plus LifelineBattery Report, Notification Report, Device Reset Locally Notification |
This setting determines whether the battery level report will be sent when the notification report is sent by the device. Size: 1 Byte, Default Value: 1
Setting | Description |
---|---|
0 | Do not send with the Notification Report |
1 | Send with the Notification Report |
Hardware Platform | ZM5202 |
Device Type | Notification Sensor |
Network Operation | Reporting Sleeping Slave |
Firmware Version | 01 |
Z-Wave Version | 6.51.06 |
Certification ID | ZC10-15060028 |
Z-Wave Product Id | 0x0178.0x4442.0x3130 |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |