Quickstart
This is a
Z-Wave Device for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Product Description
The mydlink Home Motion Sensordetects motion within its field of view, providing you with a trigger for automating your home. Integrating with D-Link&rsquos HNAP protocol, the Motion Sensor connects seamlessly with your Connected Home Hub, guaranteeing compatibility and getting your smart home network up and running right away.
- 90° motion sensor reports movements up to 10 m away from your home automation system
- easy setup with the mydlink home app for your tablet or Smartphone
- wireless connectivity
- 3-in-1 sensor for infrared (passive)
- Temperature and brightness
- D-link HNAP and Z-Wave plus Protocol compatible
- Z-Wave AES 128-bit AES encryption
- Z-Wave button for the automatic connection and manipulation protection
- Status LED
- independent power supply via the included 3V (CR123A) up to 2 years
- can be used only in conjunction with DCH G020
Reset to factory default |
XXXResetDescription |
Inclusion |
XXXInclusionDescription |
Exclusion |
XXXExclusionDescription |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Technical Data
Dimensions |
0.0000000x0.0000000x0.0000000 mm |
EAN |
790069409851 |
Certification ID |
ZC10-14100002 |
Frequency |
Europe - 868,4 Mhz |
Maximum transmission power |
5 mW |