Domitech
Z-Wave Dimmable LED Light Bulb
SKU: DOMEZBULB
Quickstart
This is a
Turning on the power switch on the wall includes or excludes the device.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The Domitech BulbZ is a Z-Wave controllable and fully-dimmable, instant-on LED screw-in light bulb that provides gorgeous soft-white illumination (2700K). Equivalent to a 60-watt incandescent bulb and using only nine (9) watts of energy, BulbZ is estimated to save approximately 140 EU throughout its average lifespan. The Bulb can be used even in two-wire electrical systems where an installation of a standard Z-Wave switch or dimmer will fail. As with all Z-Wave products, BulbZ operates at the standard 868.42 MHz frequency, acts as Z-Wave repeater and gives users the convenience of wirelessly controlling lighting from a Z-Wave hub or controller.
Installation
Just screw the bulb into a standard E27 light bulb socket.
Device Reset For device reset the device must be turned on and off 4 times in a row within 4 seconds.Product Usage
The device can be controlled from the legacy wall switch and in parallel from any Z-Wave wireless controller. It can be dimmed and switch on and off. In case the legacy wall has turned off the bulb it can not be turned on by wireless command. To prevent this a two times off/on switching sequence on the wall switch within 2 seconds (switch remains in ON-position after this) will turn off the lamp be keeps it powered. All other mixed combinations of controls are possible:
- Wall Switch ON => Lamp ON => Wall Switch OFF => Lamp OFF
- Wall Switch ON => Lamp ON => Z-Wave OFF => Lamp OFF => Z-Wave ON => Lamp ON
- Wall Switch ON => Lamp ON => Z-Wave DIM => Z-Wave OFF => Lamp OFF => Z-Wave ON => Lamp dimmed
- Wall Switch ON => Lamp ON => Z-Wave DIM => Wall Switch OFF => Lamp OFF => Wall Switch ON => Lamp dimmed
- Wall Switch ON => Lamp ON => Z-Wave OFF => Lamp OFF => Wall Switch OFF/ON => Lamp ON
- Wall Switch OFF => Lamp OFF => Wall Switch ON => Lamp ON
- Wall Switch OFF/ON/OFF/ON => Lamp OFF => Z-Wave ON => Lamp ON
- Wall Switch OFF => Lamp OFF => no Z-Wave operation
| Reset to factory default | XXXResetDescription |
| Inclusion | Turning on the power switch on the wall includes the device. For exclusion the device must be turned on and off 4 times in a row within 4 seconds |
| Exclusion | Turning on the power switch on the wall includes the device. For exclusion the device must be turned on and off 4 times in a row within 4 seconds |
| NIF | In factory reset the device will issue a NIF every time when powered. |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | Lifeline |
Technical Data
| Dimensions | 0.0600000x0.1200000x0.0000000 mm |
| Weight | 140 gr |
| Hardware Platform | ZM5202 |
| EAN | 869166000060 |
| IP Class | IP 20 |
| Voltage | 230V |
| Device Type | Light Dimmer Switch |
| Generic Device Class | Multilevel Switch |
| Specific Device Class | Routing Multilevel Switch |
| Firmware Version | 05.09 |
| Z-Wave Version | 03.5f |
| Certification ID | ZC10-15100019 |
| Z-Wave Product Id | 020e.4754.3038 |
| Frequency | Europe - 868,4 Mhz |
| Maximum transmission power | 5 mW |