Duewi
Type F Plugin Dimmer
SKU: DUW_064398
Quickstart
This is a
Plug this module into a wall outlet near the load to be controlled. Plug the load into the module and switch the load to the ON position. To turn ON the module and the load plugged into it, press and release the ON/OFF button of the module. Inclusion and Exclusion are confirmed by a tripple click of the button of the device.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The Duwi 064398 is a dimmer plug that can be placed between a type F wall outlet and electric devices, plugged in by cord. It can dim resistive loads up to 400 W. The device is IP 20 rated and can therefore only be used in dry environments. For dimming the devices apply leading edge phase cutting with a special alignment algorithm for inductive loads. It is therefore possible to dim incandescent lamps, high voltage halogen lights and low voltage halogen lights with traditional transformer. Low voltage halogen lights with switching power supply, LEDs and CFLs must not be attached. Dimming is controlled wirelessly using Z-Wave or locally applying a button. A three color LED indicates the dimming status.
Installation
The Dimmer Plug DUW_064398 can be plugged into every Standard type F wall outlet. It is IP20 rated and can therefore only be used in dry environments. Do not locate the module facing direct sunlight, humid or dusty place. The suitable ambient temperature for the module is 0°C ~ 40°C.
Product Usage
The device is able to dim all loads up to 400 W. Any load above 400 W is considered as overloading. Switching is controlled wirelessly using Z-Wave or directly over the ?ON/OFF? button of the Plugin Switch. Unplugging and replugging the module will reset the module to normal state.
A red LED indicates the dimmimging status.
| Reset to factory default | XXXResetDescription |
| Inclusion | Inclusion and Exclusion are confirmed by a tripple click of the button of the device. |
| Exclusion | Inclusion and Exclusion are confirmed by a tripple click of the button of the device. |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Technical Data
| Dimensions | 0.0580000x0.1050000x0.0070000 mm |
| Weight | 160 gr |
| EAN | 4008297064398 |
| Device Type | Light Dimmer Switch |
| Generic Device Class | Multilevel Switch |
| Specific Device Class | Routing Multilevel Switch |
| Firmware Version | 01.00 |
| Z-Wave Version | 02.24 |
| Certification ID | ZC08-08090009 |
| Z-Wave Product Id | 0064.1001.0000 |
| Frequency | Europe - 868,4 Mhz |
| Maximum transmission power | 5 mW |