Quickstart
This is a
Notification Sensor for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
Once the controller is in inclusion mode, either remove the battery isolation tab, OR insert the battery to power up the sensor.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Ecolink Z-Wave Door/Window Sensor-Z-Wave Plus certified-Frequency 908.42MHz-Range up to 100 feet-Battery life up to 3 years with 50 openings/closing per day-CR123A Lithium battery-Input on the sensor for non-powered external contact-BOTH brown and white cases included in each box
Reset to factory default |
To restore this sensor to factory default settings, follow the instructions in the manual to exclude this sensor from the Z-Wave network. Upon completion of removal from the network the sensor will restore itself to factory default settings automatically.Use this procedure only in the event that the network primary controller is missing or otherwise inoperable. |
Inclusion |
Once the controller is in inclusion mode, either remove the battery isolation tab, OR insert the battery to power up the sensor. |
Exclusion |
Once the controller is in exclusion mode, either remove the battery isolation tab, OR insert the battery to power up the sensor. |
NIF |
XXXNIF |
Wakeup |
If sensor is sleeping, remove the cover to wake up. |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Z-Wave Plus Lifeline |
2 |
5 |
Used to activate other devices directly |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Notification Sensor |
Network Operation |
Reporting Sleeping Slave |
Z-Wave Version |
6.51.06 |
Certification ID |
ZC10-15090018 |
Z-Wave Product Id |
0x014A.0x0001.0x0002 |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |