This is a
Plug this module into a wall outlet near the load to be controlled. Plug the load into the module and switch the load to the ON position. To turn ON the module and the load plugged into it, press and release the ON/OFF button of the module. Inclusion and Exclusion are confirmed by a tripple click of the button of the device.
The AD1426 is a dimmer plug that can be placed between a wall outlet for Plug Type E (France, Poland, …) and electric devices, plugged in by cord. It can dim resistive loads up to 400 W. The device is IP 20 rated and can therefore only be used in dry environments. For dimming the devices apply leading edge phase cutting. Therefore, it is only possible to dim incandescent lamps and high voltage halogen lights. Low voltage halogen lights, LEDs and CFLs must not be attached. Dimming is controlled wirelessly using Z-Wave or locally applying a button. A red LED indicates the dimming status.
The device can be plugged into every standard Schuko outlet (plug type E). Do not locate the Module facing direct sunlight, humid or dusty place. The suitable ambient temperature for the module is 0°C ~ 40°C.
The device is able to switch and measure any electric load up to 400 W. Any load above 400 W is considered as overloading. When overloading is detected the device will turn off the load, lock the local button and indicate the status by flashing the LED for 30 sec. Unplugging and replugging the module will reset the module to normal state. The electrical load can be switched using wireless commands and operating the local button. The LED inside the local button will indicate the dimming status.
Reset to factory default | Tripple Click the button (same as for inclusion/exlusion) plus pushing the button again within 1 sec and hold it down for 5 sec. |
Inclusion | Inclusion and Exclusion are confirmed by a tripple click of the button of the device. |
Exclusion | Inclusion and Exclusion are confirmed by a tripple click of the button of the device. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Dimensions | 0.0060000x0.0090000x0.0070000 mm |
Weight | 150 gr |
Device Type | Light Dimmer Switch |
Generic Device Class | Multilevel Switch |
Specific Device Class | Routing Multilevel Switch |
Firmware Version | 00.01 |
Z-Wave Version | 02.18 |
Certification ID | ZC08-09070008 |
Z-Wave Product Id | 0060.0103.0001 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |