Quickstart
This is a
Light Dimmer Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
1. Put the Z-Wave Controller into inclusion mode.
2. Press the link key three times within 1.5 seconds to put the unit into inclusion mode.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Product Description
The mini Dimmer Plug is designed to control the on/off status of lighting and appliance load in your house. The unit also provides dimmer function which is only applicable to light bulbs. At 220-240V voltage, this Dimmer Plug can support connected load of 6W - 250W.
Reset to factory default |
1. Press the link key three times within 1.5 seconds to put the unit into exclusion mode.
2. Within 1 second of step 1, press link key again and hold it until LED is off (about 5 seconds).
3. Node ID is excluded. The device reverts to factory default state and will be in auto-inclusion mode for 4 minutes.
4. Use this procedure only in the event that the network primary controller is missing, or otherwise inoperable |
Inclusion |
1. Put the Z-Wave Controller into inclusion mode.
2. Press the link key three times within 1.5 seconds to put the unit into inclusion mode. |
Exclusion |
1. Put the Z-Wave Controller into exclusion mode.
2. Press the link key three times within 1.5 seconds to put the unit into exclusion mode. |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
4 |
General:NA Z-Wave Plus Lifeline |
2 |
4 |
Control:Key1 On/Off control (Button1) |
Technical Data
Dimensions |
0.0520000x0.0520000x0.0760000 mm |
Weight |
84 gr |
Hardware Platform |
SD3502 |
EAN |
0019962012600 |
Device Type |
Light Dimmer Switch |
Network Operation |
Always On Slave |
Z-Wave Version |
6.51.02 |
Certification ID |
ZC10-15100008 |
Z-Wave Product Id |
0x0060.0x0003.0x0003 |
Frequency |
Europe - 868,4 Mhz |
Maximum transmission power |
5 mW |