Quickstart

This is a Binary Power Switch for XXXQFrequencyName. To run this device please connect it to your mains power supply.

Screw the device into a E27 lamp socket and screw the light bulb into the device. Inclusion and Exclusion are confirmed by a click of the button of the device.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

The Everspring Lamp holder allows controlling an electrical load both wirelessly via Z-Wave and locally using the ON-/OFF button on the device. After the module is included into the controllers Z-Wave network, the lamp can be switched ON/ OFF by every associated device in the network. Pressing the On/Off button on the device will control directly the On/Off status of the connected incandescent lamp without using the wireless controller. This lamp holder is designed for 100W incandescent lamps and energy saving bulbs with a maximum load of 27W.

Installation

The device can be plugged into every E 27 Light bulb socket. Do not locate the Module facing direct sunlight, humid or dusty place. The suitable ambient temperature for the module is 0°C ~ 40°C.

Product Usage

The device is able to switch a light bulb up to 100 W. The electrical load can be switching using wireless commands and operating the local button. The LED inside the local button will indicate the switching status.

Reset to factory default XXXResetDescription
Inclusion

Inclusion and Exclusion are confirmed by a click of the button of the device.

Exclusion

Inclusion and Exclusion are confirmed by a click of the button of the device.

NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Association Groups:

Group Number Maximum Nodes Description
1 1 Lifeline

Technical Data

Dimensions 0.0700000x0.0900000x0.0500000 mm
Weight 103 gr
EAN 4713616113113
IP Class IP 20
Voltage 230 V
Load 100W
Device Type Binary Switch
Generic Device Class Binary Switch
Specific Device Class Binary Power Switch
Firmware Version 01.02
Z-Wave Version 02.40
Certification ID ZC08-09100004
Z-Wave Product Id 0x0060.0x0004.0x0001
Frequency Europe - 868,4 Mhz
Maximum transmission power 5 mW
EuropeBinary Switch