Quickstart

This is a Binary Power Switch for XXXQFrequencyName. To run this device please connect it to your mains power supply.

 

Inclusion and Exclusion are confirmed by a tripple click of the button of the device.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

The Everpring AN1576 is a switch plug that can be placed between a wall outlet for Plug-Type E (France, Poland, ...) and electric devices, plugged in by cord. It can switch all loads up to 3500 W. The device is IP 20 rated and can therefore only be used in dry environments. Switching is controlled wirelessly using Z-Wave or locally applying a button. A red LED indicates the switching status.

Installation

The device can be plugged into every standard Schuko outlet. Do not locate the Module facing direct sunlight, humid or dusty place. The suitable ambient temperature for the module is 0°C ~ 40°C.

Product Usage

Plug this module into a wall outlet near the load to be controlled. Plug the load into the module and switch the load to the ON position. To turn ON the module and the load plugged into it, press and release the ON/OFF button of the module.

The device is able to switch and measure any electric load up to 3000 W. Any load above 3000 W is considered as overloading. When overloading is detected the device will turn off the load, lock the local button and indicate the status by flashing the LED for 30 sec. Unplugging and replugging the module will reset the module to normal state. The electrical load can be switching using wireless commands and operating the local button. The LED inside the local button will indicate the switching status.

Reset to factory default XXXResetDescription
Inclusion tripple click of the button of the device.
Exclusion

tripple click of the button of the device.

NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Dimensions 0.0060000x0.0090000x0.0070000 mm
Weight 140 gr
Device Type On/Off Power Switch
Generic Device Class Binary Switch
Specific Device Class Binary Power Switch
Firmware Version 01.02
Z-Wave Version 02.40
Certification ID ZC08-09070011
Z-Wave Product Id 0060.0004.0001
Frequency Europe - 868,4 Mhz
Maximum transmission power 5 mW
EuropeOn/Off Power Switch