Everspring
On/Off Mini plug
SKU: EVR_AN1802
Quickstart
This is a
Press the link key three times within 1.5 seconds to put the unit into inclusion mode.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The On/Off Mini Plug is a Z-WaveTM enabled device which is fully compatible with any Z-WaveTM enabled network. Z-WaveTM enabled devices displaying the Z-WaveTM logo can also be used with it regardless of the manufacturer, and ours can also be used in other manufacturer‘s Z-WaveTM enabled networks. Inclusion of this unit on other manufacturer‘s Wireless Controller menu allows remote operation of the unit and the connected load.
The On/Off Mini Plug is designed to control the on/off status of appliances load in your house. At 220-240V voltage, this Plug can support up to 1500W resistive.
Installation
Just plug the device into an Type-F outlet
Product Usage
The device will work on Type-F outlets only. It allows remote switching and metering of the load attached.
| Reset to factory default | 1. Press the link key three times within 1.5 seconds to put the unit into exclusion mode. 2. Within 1 second of step 1, press link key again and hold it until LED is off (about 5 seconds). |
| Inclusion | Press the link key three times within 1.5 seconds to put the unit into inclusion mode. |
| Exclusion | Press the link key three times within 1.5 seconds to put the unit into inclusion mode. |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 1 | Binary Switch Report,Notification Report,Device Reset Locally Notification,Meter ReportZ-Wave Plus Lifeline |
| 2 | 4 | Basic SetOn/Off control (Button1) |
Configuration Parameters
Parameter 1: Set Basic Set Command value
Size: 2 Byte, Default Value: 255
| Setting | Description |
|---|---|
| 0 - 99 | value |
| 255 | value |
Parameter 2: Set the delaying time to report to Group 1
Size: 1 Byte, Default Value: 3
| Setting | Description |
|---|---|
| 3 - 25 | seconds |
Parameter 3: Set whether to remember the last status
Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | do not remember |
| 1 | remember |
Technical Data
| Dimensions | 0.0515100x0.0775000x0.0515100 mm |
| Weight | 82.94 gr |
| Hardware Platform | SD3502 |
| EAN | 4713616113533 |
| IP Class | IP 20 |
| Voltage | 230 V |
| Load | 1500 W |
| Device Type | On/Off Power Switch |
| Network Operation | Always On Slave |
| Z-Wave Version | 6.51.02 |
| Certification ID | ZC10-15090003 |
| Z-Wave Product Id | 0x0060.0x0004.0x0007 |
| Frequency | Europe - 868,4 Mhz |
| Maximum transmission power | 5 mW |