Quickstart

This is a Binary Switch for XXXQFrequencyName. To run this device please insert fresh 4 * LR14 batteries. To run this device please make sure the internal battery is fully charged.

For Inclusion and Exclusion push the Inclusion/Exclusion Switch behind the rear cover quickly 3 times.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

The Siren SE812 Siren will warn everybody in the building by a loud sound and a flashing light about an alarm. This product is especially suited to use in combination with other Z-Wave devices such as sensors. The SE812 Siren gives a loud sound and a flashing warning light, so everybody in the building will know immediately that an alarm has occurred. You can choose to activate the siren either by burglary alarm or by a smoke alarm or activate the siren by both alarms. It is even possible to install multiple sirens, so the alarm can be heard loudly at multiple locations. The SE812 Siren has an adjustable jumper inside, so you can choose between either a 90dB or a 100 dB volume of the siren. Choose either the included batteries or a power supply to power your siren. When using batteries, the siren will give a warning when the batteries are almost empty.

Installation

1. Undo and remove the fixing screws from the bottom edge of the Indoor Siren and remove the rear cover.

2. Insert four LR14 1.5V size alkaline batteries to the battery compartment, ensuring correct polarity.

3. You can use power adapter instead of batteries. The power adapter is an optional accessory. A cable track is set inside the unit for you to secure the power adapter. To install the power adapter, connect the plug of power adapter to the DC jack inside the unit. Route the cable along the cable track.

4. There are two jumpers on the backside to set sound level and tamper switch. With the upper jumper the sound level can be set to 90db or 100db. With the lower jumper the tamper switch can be enabled or disabled.

5. Use the rear cover as a mounting plate, mark the positions of the three fixing holes on the wall. Fasten the rear cover to the wall using the screws and wall plugs provided.

Product Usage

Self-Protection Mode: Once the device is closed for three seconds and the tamper switch is activated it will give an alarm for 3 minutes, if it is violent opened or manipulated. When the siren is in the normal mode and an associated device triggers an alarm the siren and the flash light will be activated.

Reset to factory default XXXResetDescription
Inclusion

 click the inclusion/exclusion switch quickly 3 times. The green LED is on and the siren beeps when the switch is pressed.

 

Exclusion

click the inclusion/exclusion switch quickly 3 times. The green LED is on and the siren beeps when the switch is pressed.

 

NIF XXXNIF
Wakeup

Tripple click on the inclusion/exclusion switch or a detected action by the sensor will wake up the device and keep it awake.

Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Dimensions 0.0900000x0.1550000x0.0490000 mm
Weight 190 gr
Hardware Platform ZM3102
EAN 4713616113052
Battery Type 4 * LR14
Device Type On/Off Power Switch
Generic Device Class Binary Switch
Specific Device Class Binary Switch
Firmware Version 00.00
Z-Wave Version 02.40
Certification ID ZC08-12020009
Z-Wave Product Id 0060.000c.0001
Frequency Europe - 868,4 Mhz
Maximum transmission power 5 mW
EuropeOn/Off Power Switch