This is a
Inclusion, Exclusion and wakeup are confirmed by three seconds clicking the tamper switch (Z-Wave Button) on the backside of the case.
This sensor monitors leakage and sends an alarm when flooding or leakage is detected. The sensing device can be away up to 3 m from the main device. The unit can be mounted on every flat surface. The installation can be done with screws or double-sided tape.
The ST812 is a battery-powered device, which is in non-operating state unless an action is detected. After a programmable sleeping time the device wakes up and sends status information. After this the unit goes back to non-operating state. Batteries can be changed without unscrewing the device from the door or frame. The unit will give a visual warning on the device and sends a warning to the Z-Wave controller, when batteries need to be replaced. The units send information to a controller or any other associated Z-Wave device. Up to 4 devices can be controlled from this device.
The device needs to be included into a Z-Wave network by a remote control or any other Z- Wave controller. For configuration of certain behavior a static controller such as a PC with home automation software or a gateway is recommended.
1. Release the Sensor from the mounting plate and the battery cover by removing the fixing screws.
2. Put the 3 * AA 1.5V batteries in the battery compartment.
3. For mounting use mount plate and the screws.
4. Refit the device to the back cover and secure with the fixing screw.
A clean smooth surface is required to mount the Flood Detector securely. The length of flood sensor cable is 3 meters. If a 3-meter cable is too long, roll up the cable and fasten it by twist ties. The transceiver should be placed as high up as possible on the wall to improve communication and to prevent it from coming into contact with water in case of flooding.
Reset to factory default | XXXResetDescription |
Inclusion | Make sure that your Z-Wave Controller is in the Inclusion-/Exclusion-Mode. Click three seconds on the tamper switch (Z-Wave Button) behind the mounting plate to confirm the process. |
Exclusion | Make sure that your Z-Wave Controller is in the Inclusion-/Exclusion-Mode. Click three seconds on the tamper switch (Z-Wave Button) behind the mounting plate to confirm the process. |
NIF | Click three seconds on the tamper switch (Z-Wave Button) behind the mounting plate or a detected action by the sensor sends a Node Information Frame. |
Wakeup | Click three seconds on the tamper switch (Z-Wave Button) behind the mounting plate or a detected action by the sensor will wake up the device and keep it awake. |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Devices controlled by open/close events |
Dimensions | 0.0850000x0.0850000x0.0390000 mm |
Weight | 170 gr |
Hardware Platform | ZM3102 |
EAN | 4713616113212 |
Battery Type | 2 * AA |
Device Type | Routing Binary Sensor |
Generic Device Class | Binary Sensor |
Specific Device Class | Routing Binary Sensor |
Firmware Version | 01.03 |
Z-Wave Version | 02.40 |
Certification ID | ZC08-09100002 |
Z-Wave Product Id | 0086.0002.0004 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |