This is a
This sensor measures the amount of light at a certain place. The local LCD display shows the actual values and the historical minimum/maximum value. The unit can be mounted on every flat surface. The installation can be done with screws or double-sided tape.
The ST815 is a battery-powered device, which is in sleeping state unless an action is detected. After a programmable sleeping time the device wakes up and sends a status information. After this the unit goes back to sleeping modus. Batteries can be changed without unscrewing the device from the door or frame. The unit will give a visual warning on the device and sends a warning to the Z-Wave controller, when batteries need to be replaced. The units send information to a controller or any other associated Z-Wave device. Up to 4 devices can be controlled from this device.
The device needs to be included into a Z-Wave network by a remote control or any other Z- Wave controller. For configuration of certain behaviour a static controller such as a PC with home automation software or a gateway is recommended.
Reset to factory default | XXXResetDescription |
Inclusion | XXXInclusionDescription |
Exclusion | XXXExclusionDescription |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Dimensions | 0.0000000x0.0000000x0.0000000 mm |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |