This is a
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
FIBARO Wall Plug is a HomeKit-enabled smart plug using Wi-Fi connection and Bluetooth low energy wireless technology. This remotely controlled outlet adapter is equipped with an active power and energy metering function. It uses a LED ring to visualize current consumption and status. The Wall Plug may be operated using the button on the casing or via an iOS mobile app through Wi-Fi.
Features:
technical Details:
Use Case:
1. Certainty - Now you do not have to go back to check whether you have turned off the iron, FIBARO WallPlug keeps an eye on plugged in devices.
2. Gentle illumination - The Wall Plug"s amazing LED ring illuminates with a pale blue or white light while it’s connected to the power outlet, which ideally plays a role of a bedside lamp.
3. Just in time - works on schedule
4. Parental control - control your children"s learning time or fun and automatically turn off potentially dangerous devices when you are not around.
5. Money-savings - With schedules of devices, it is possible to switch them on the night rate - when the fees are lower.
6. Smart management - Turns off in stand-by mode.
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Here are a few hints for network installation if things dont work as expected.
Dimensions | 0.0420000x0.0420000x0.0660000 mm |
Weight | 55 gr |
EAN | 5905279987852 |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |